BUG Community

Welcome! Log In

Forums BUGmodules BUGview REcalibration

Subscribe to BUGview REcalibration  4 posts, 3 voices

Log in to reply to this topic
Dec 12, 2008 11:39pm
Img_missing_medium bear912 8 posts

I noticed that the BUGview module walked me through a calibration process the first time I connected it to the BUGbase. Since my original calibration is a bit off (I probably calibrated it with my thumb :-P I was too excited to look for a stylus), I was wondering how this process could be repeated. Any tips?

Dec 13, 2008 9:51am
Medium Bug Labs team finsprings 268 posts

If you connect to your BUG via serial or SSH you can ‘rm /etc/pointercal’ and then restart (X or the whole BUG) and it should prompt you to do the calibration again.

Dec 13, 2008 9:54am
Medium Bug Labs team jconnolly 285 posts

the exact commands are:

root@bug:~# rm /etc/pointercal
root@bug:~# /etc/init.d/xserver-nodm-bug restart
Dec 13, 2008 8:38pm
Img_missing_medium bear912 8 posts

Thank you. BUGview freshly calibrated, and working beautifully.

Log in to reply to this topic
Forums BUGmodules BUGview REcalibration

Powered by Community Engine